Author Topic: Whirlpool washer will only begin spin after I open lid (Read 2259 times)

agurnsey · « **on:** February 20, 2012, 05:08:30 PM »

I have a whirlpool washer that will only kick into the spin after I open and then close the lid. I have to fully open the lid so I don't believe it is a lid switch problem. Occasionally it will start to spin on it's own, but 9 times out of 10 I have to kick start it. I'm thinking timer? Any thoughts?

bigbuck · « **Reply #1 on:** February 20, 2012, 05:30:48 PM »

What's. Your model number?!

Sent from my MB865 using Tapatalk

agurnsey · « **Reply #2 on:** February 20, 2012, 05:45:39 PM »

Sorry. Model number is LSR5232LQ0.

It only fails to spin after the first drain. If I get to it while it's draining and open the lid it immediatley begins to spin. If I don't open the lid it appears that it does not spin at any cycle.

Thanks for any insight!
Amy

bigbuck · « **Reply #3 on:** February 20, 2012, 05:53:33 PM »

Yes, on this model it suppose to pause after drain & then go into spin, controlled by timer. Timer has the pause before it can engage into spin. So yes timer sounds correct.

Sent from my MB865 using Tapatalk

timer number is AP3037984

RegUS_PatOff · « **Reply #4 on:** February 21, 2012, 07:04:06 AM »

yes, I agree, Timer
unless, the Washer is in a cold room less than 60F

Get Answers to your Appliance Repair Questions

ApplianceJunk.com

Appliance Repair Forum