Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Kenmore 70 Series Washer is not Spinning  (Read 4811 times)

Offline Ciaranra

  • VIP Member
  • Member Since: Jun 2011
  • Posts: 1
Kenmore 70 Series Washer is not Spinning
« on: June 24, 2011, 06:16:23 AM »

Hi, my Kenmore 70 series washer (110.22702100) is not spinning; however, it is draining. When it is on the spin cycle if I open the lid, hold down the lid switch, and give the basket a little spin myself it starts spinning on its own. It does not appear to spin as fast as it should, though. I have tried this with a light load.

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8809
  • Country: us
  • SublimeMasterJW
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Kenmore 70 Series Washer is not Spinning
« Reply #1 on: June 24, 2011, 10:20:59 AM »
That sounds to me like yall need to install a new clutch however when you remove the case and you see this: Click on first photo; If oil is on the inside of the case then a simple seal replacement will be all that is needed. Jumpy recommends you clean the clutch with brake cleaner after repairing that seal. To replace the seal remove the cover and pop out the old one. Put a little oil on the seal and tap it back into the tranny cover with a hammer using a wood block to keep from harming the seal.


WHIRLPOOL Clutch Assembly, part number: AP3094537




May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair and other general BS I love to post. The letter sends me email.
I love fan letters! LOL