Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Door will not lock  (Read 1933 times)

Offline csv

  • VIP Member
  • Member Since: May 2011
  • Posts: 1
Door will not lock
« on: May 27, 2011, 09:25:59 AM »

After replacing the control board and wax motor because the door would not unlock, now the door will only lock just before the spin cycle where it use to look before the wash cycle. Is is now normal as I know Maytag had a problem with the control boards and wax motors.
P.S I use the information from this site Topic: Maytag Neptune MAH4000AWW - No Spin

Offline Ironhorse

  • VIP Member
  • Member Since: Jun 2011
  • Posts: 11
Re: Door will not lock
« Reply #1 on: June 06, 2011, 06:41:26 PM »
The fact that the door is not locking right away is not a big issue, the new software should lock the door sometime prior to the first pump out of the wash water.  Is it working fine other then that change?