Author Topic: frigidaire front loading washer wont start up and start light just flashes (Read 10034 times)

tjthetech · « **on:** March 01, 2011, 11:45:11 AM »

frigidaire front loading GLTf2940ES3 washer wont start up and start light just flashes! if i hold down the start and pause/cancel buttons down together the error code e6e pops up. Is there anyone who can solve this problem or has ran into this problem before please help!

AJ · « **Reply #1 on:** March 02, 2011, 09:50:37 AM »

Never run into this myself. Why are you holding down the start and pause/cancel buttons together?

Does it fill with water?

Did you find the tech sheet inside?

JWWebster · « **Reply #2 on:** March 02, 2011, 02:32:28 PM »

You must have the washer in the test mode. Unplug the washer for 8 seconds and reconnect it then retry.

boyax · « **Reply #3 on:** March 16, 2011, 07:57:33 AM »

I think E6E means Error-6E
6 = belongs to the heater fault family, and may include problems caused by faulty heater thermofuse or water temperature sensor
I'm not sure about the last "E", sorry
Hope this could help

krazytech · « **Reply #4 on:** March 16, 2011, 08:23:03 PM »

undocumented E6E error code is a bad interface control board

Get Answers to your Appliance Repair Questions

ApplianceJunk.com

Appliance Repair Forum