I have a Sears Kenmore front load washer, mfg. approx. 06/05. The model/serial are completely obliterated from the sticker inside the door. The matching dryer model is 417.84692500
(you can still read that sticker)
The washer was running a load of towels when it became unbalanced and actually moved itself to the left. (Dryer mounted on top; no pedestals). It did not finish that cycle; towels were soaked. If you press start, the door locks, all lights seem normal on control screen.
The power comes on, no error messages, then the machine will pump a pint or so of water in or out, then the pump stops. There is a slight motor hum; the control lights and timer work (slower than normal; I set it for a 13 minute rinse/spin cycle that seemed to take 25+ minutes for the timer to complete).
From this information, can you suggest a troubleshoot or solution?