Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Kenmore refrigerator - how remove ice/water dispenser front panel  (Read 39123 times)

Offline Marvster

  • VIP Member
  • Member Since: Aug 2007
  • Posts: 2

I need to replace the 'water fitting assembly' in the ice/water dispenser in the freezer door on a side-by-side (model 106.59582990- manufactured circa August 1999).  There is not near enough room to work through the front panel so would like to remove it.  I see no screws.  Is it a snap out (if so, how - bottom/top??) ? Or? ??? ??? ??? ??? ?
Thanks in advance for any advice/assistance.........

Refrigerator Water Fitting Assembly Part # 4388152

Offline AJ

  • Technician
  • Member Since: Jun 2007
  • Posts: 10993
  • Country: us
    • - Appliance Repair
Re: Kenmore refrigerator - how remove ice/water dispenser front panel
« Reply #1 on: August 11, 2007, 08:06:07 PM »
Hi Marvster,

Yes, the front panel should just snap off.
If you look under the bottom edge there is often a couple small slots.
Put a flat blade screwdriver in the slot and pop the front off.