KENMORE WASHER 60 series

[amnesty]

  Well im confused and frustrated with my washer, 110.92060110. Its old and now it wont spin and rince! I turn the knob manualy and it works on one cycle
So, I know it can still rince and spin but it just wont when it sapposed to.
I been using it that way for a fiew months  
However it takes forever and was gonna get a new washer. I dont think I need one, what do you think I can do about fixing mine and were do I get the parts?
Thank you for your help with my dryer a fiew months back!
Still works good I fixed it with your help

Model 110.92060110

[whirlpooltech]

Hi amnesty,

Could you check your model number again.
I think it maybe missing some numbers.

Would there maybe be a 110. in front of them other numbers?

[JWWebster]

110.92060110 add a 110. to any kenmore model number(washers and dryers whirlpool) It is a direct drive model. You say you can make it spin  by manually manipulating the the washer. I hear ya. That has got to be the timer. It will do all the funnctions but you just gotta figure out how. I was leaning on one one time. Literally leaning on the lid and messing with the timer to make one spin. I noticed the lid was loose. It was not catching the striker to the lid switch like it was supposed to.  Is your lid loose? if it ain't  I would say replace the timer.

[amnesty]

model# 110.92060110
here is the whole model # sorry about that.

[JWWebster]

If you can move the timer around and everything works, then I would say the timer motor is not advancing. You could try oiling it, but it probably needs replacement.

[amnesty]

So, seen a video an how to get to the timer. Do you have one for kenmore or are they all pretty much the same?
If there is a wideo what video do you recamend?

Im going to try and take a look at my timer today. Also were do I oil it?

[JWWebster]

http://www.youtube.com/watch?v=IDMrhyEuYwM&feature=related

[JWWebster]

Once you flip up this console then the timer is easily accessed. The knob unscrews then you remove the dial indicator(escrution) this will expose the 2 5/16th inch hex heads that hold the timer in place. after these 2 are removed the timer simply has a quick disconnect. If you have a credit card you might can send the timer to be rebuilt to midwest timers in Michigan. Midwest Timer Service, Inc.
4815 N. M-63
Benton Harbor, MI 49022-9533
Phone 269-849-2800