Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Maytag LAT9356AAE Spin problem  (Read 7411 times)

Offline Camarocam

  • VIP Member
  • Member Since: Feb 2008
  • Posts: 2
Maytag LAT9356AAE Spin problem
« on: February 18, 2008, 11:12:02 AM »

  My washer will not go into the spin cycle, it spins but not at like a normal wash speed not quickly enough to dry the clothes. It worked fine before I replaced the driveshaft seal? The trasmisson spins just very slow. I looked at the bottom where the pulley is, it spins fast no slipping of the belt but if I push the motor in on the slid its like the transmission switchs gears because then the trans speeds up and the bottom pulley slows down but still not as fast as it should be?

Model LAT9356AAE

Offline AJ

  • Technician
  • Member Since: Jun 2007
  • Posts: 10998
  • Country: us
    • - Appliance Repair
Re: Maytag LAT9356AAE Spin problem
« Reply #1 on: February 19, 2008, 11:06:24 AM »

Have you tried a new belt?

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3023
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Re: Maytag LAT9356AAE Spin problem
« Reply #2 on: February 20, 2008, 10:10:40 AM »
Apparently somewhere in your repair process, the spin bearings are binding.

1.To what extent did you tear down the machine?

2. Did you have  cause to remove the large drive pulley on bottom for any reason?
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman