Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Video: Testing - Connect and disconnect a push-in ice maker water fill valve  (Read 23039 times)

Offline AJ

  • Technician
  • Member Since: Jun 2007
  • Posts: 10865
  • Country: us
    • - Appliance Repair

IMPORTANT NOTE: For no ice or low ice production, always confirm normal (0-5 Deg F) freezer temperatures before beginning diagnostic checks. The ice maker is designed not to run if the freezer in  not in this temperature range.

In this example I am using a ice maker water fill valve for a whirlpool side by side refrigerator.

The push-in fitting is a very common type of connection used on many different refrigerator water systems.

Disconnecting a push-in fitting

Shut off the water supply and depressurize the system. Push the collet (gripper) firmly against the fitting and pull the tube away from the fitting.

Connecting a push-in fitting

For a proper seal, all tube ends inserted into a push-in fitting must be round and free from surface damage.

To insert, push the tube firmly into the push-in fitting until the tube contacts the tube stop. When inserting the tube, one will encounter some resistance when the tube contacts the o-ring seal. Push the tubing through the o-ring seal until the tube contacts the tube stop. Pull on the tube firmly to verify it is secure. Turn on the water and check for leaks.

If your ice maker is not getting any water the fill tube could just be frozen shut.
Pull the refrigerator out from the wall and disconnect the power.
Follow the plastic water line that runs from the ice maker down to the water valve.
To be safe, turn the water to the refrigerator off.

Remove the water line (at the valve end) that runs up the back of the wall to the ice maker.
Put it to your mouth and try to blow air though it. It should always be open so you can blow air though it.

If you can not blow air though it then that is why you have no water going to the ice maker, the line is frozen shut and need to be thawed out. If you have to keep thawing the fill tube out then you will want to install a [url=]Fill Tube and Heater Kit [/url]icon .

If the line is not frozen shut then you need to check the water valve with a ohm meter.

It should check around 200-300 ohms. If the valve is bad you will not get any reading, just as if you did not even have the meter connected to the valve. If you do not get any reading with the meter then replace the water valve.

Even if the valve checks ok with the meter it could still be plugged (not frozen) inside the valve or just stuck.

If everything checks ok with the valve, but you still don't get water then it is time to check the rest of the ice maker system to see if you can get water to run through the valve to the ice maker.

Make sure you reconnect the water valve and turn the water back on before testing the checking the rest of the ice maker system
322658A R-92 Whirlpool and KitchenAid Indoor Ice System - Ice Maker Service Repair Manual

WHIRLPOOL Complete Icemaker Assembly (8 Cube), part number: AP3182733

This icemaker is for 25-27 cubic feet models that have vertical auger dispenser installed in the freezer door. 8 cube icemaker.

WHIRLPOOL 4389102 Refrigerator P.c. Board Kit, AP3137510

Related Topics:
Top Ten Whirlpool and KitchenAid Indoor Icemaker Repair Topics
2002 Whirlpool Icemaker - IDI - 3rd unit - need help
Ice maker still not working?
kenmore ice maker
Kenmore SxS Model 106.56563400 Ice Maker Problems
kitchenaid (icemaker problem) wiring harden troubleshooting
Whirlpool Gold Ice Maker not working- please help
Still making too much ice
kenmore icemaker (no ice)
Kenmore 106.52552100 ice maker problems
Whirlpool Ice Maker will not make ice
Whirlpool ice maker problems
« Last Edit: January 10, 2008, 12:24:54 PM by AJ »


2315508 Whirlpool Ice Maker Water Inlet Fill Valve

Started by AJ

Replies: 0
Views: 7450
Last post April 03, 2009, 12:44:46 PM
by AJ
4389177 Whirlpool Refrigerator Ice Maker Water Inlet Fill Valve

Started by AJ

Replies: 0
Views: 10364
Last post April 07, 2009, 12:32:06 PM
by AJ
4389178 Whirlpool Refrigerator Ice Maker Water Inlet Fill Valve

Started by AJ

Replies: 0
Views: 7578
Last post April 19, 2009, 11:16:54 PM
by AJ
Whirlpool Gold Ice Maker Will Not Fill With Water But Fill Valve Works if Jumped

Started by Joe_G

Replies: 4
Views: 1473
Last post January 25, 2016, 12:12:15 PM
by Joe_G
Video: Whirlpool In-Door Ice Maker Fill Cycle

Started by AJ

Replies: 3
Views: 14363
Last post September 23, 2008, 05:37:19 PM
by Al Capone
Video: How to make your Whirlpool ice maker run for testing and diagnostics

Started by AJ

Replies: 10
Views: 71514
Last post April 16, 2013, 10:40:23 PM
by charlenemhj