Ok, I installed the new clutch and put it all back together. It still won't spin though. When I was putting it together I noticed that the center shaft didn't seem right. When you remove the the center piece that agitates you can see that it looks like the tub is sitting to low, maybe about an inch. When I lift it, it will grab the little plastic piece like it should which would engage the tub. Should it sit higher or am I wrong about that? Those two metal tabs in there weren't worn but they are a little bent. Any more ideas would help. Also, can I just turn the knob to spin to check the operation or do I have to start the cycle from the very beginning. Thanks.