Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: GE lack of agitation  (Read 2539 times)

Offline Yogi.304

  • VIP Member
  • Member Since: Jun 2009
  • Posts: 3
GE lack of agitation
« on: June 02, 2009, 08:41:13 PM »

The agitator, (and shaft) have 90 degrees of freedom, and often don't get connected during the agitation cycle.  Is this most likely to be mechanical, or electrical, and how do I get started trouble shooting it.  (or should I skip that part, and just shoot it?)  It is about three years old, and was used for two years, then spent a year in storage.  It worked a few times before acting up, and refusing to agitate.  (It makes a loud clicking noise when it as malfunctioning)

Model WBXR1060TAWW

Offline Mr. Fix-It

  • Technician
  • Member Since: Jan 2009
  • Posts: 369
  • Country: ca
Re: GE lack of agitation
« Reply #1 on: June 03, 2009, 06:58:20 AM »
The first thing I would check is the agitator coupling. The agitator pushes down on top of it and the splines sometimes strip. If the coupling is Ok then I think you probably have a bad transmission.

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8827
  • Country: us
  • Caregiver, DIYer
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: GE lack of agitation
« Reply #2 on: June 03, 2009, 10:21:23 AM »
As Mr Fixinator says, here is most likely the part you will need to replace:
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair