Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: kitchenaid (icemaker problem) wiring harden troubleshooting  (Read 10195 times)

Offline channel32a

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 5
kitchenaid (icemaker problem) wiring harden troubleshooting
« on: April 26, 2009, 11:04:42 AM »

I got this unit was an open box and customer said it never made ice and tech try everything to repair it :tickedoff:........ I have by pass the optics board and everything works great. Got it to make ice... but I notice that the wiring harden had the wires skipping instead of sequences 1-4 skip5 6 skip7 8

Does someone have the schematic for receiver board and wiring hardens for this unit???

on my
receiver wring hardens


8 - white
7- skip
6- yellow/blue
5-blue/yellow
4-black
3- skip
2- brown/white
1- orange/black

emitter wring hardens
4-white
3-brown/white
2-orange/black
1-blue/yellow

SO where does the black wire and blue yellow connect too on the receiver board and are they reverse ???

Model Number: KSCS25FTSS02 icon

Offline RegUS_PatOff

  • Technician
  • Member Since: Dec 2007
  • Posts: 1410
  • Country: us
After leaving this Earth, "Do you want the smoking or non-smoking section?"

Offline channel32a

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 5
Re: kitchenaid (icemaker problem) wiring harden troubleshooting
« Reply #2 on: April 26, 2009, 09:52:11 PM »
Thanks great help .....it started flash now that it is connect correct....  still wait to create ice and dispense ... waiting game now..

Offline channel32a

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 5
Re: kitchenaid (icemaker problem) wiring harden troubleshooting
« Reply #3 on: April 26, 2009, 10:09:49 PM »
Do I have to reset anything to get the icemaker back on time????

Do you have status of the LED for the output codes.



Offline channel32a

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 5
Re: kitchenaid (icemaker problem) wiring harden troubleshooting
« Reply #4 on: April 27, 2009, 10:04:56 PM »
a Day later no ice.. I do get the LED flash now that the wiring is correct...  also When bypass the optics I  got water to fill the ice maker.....
 
Now I am wait for the water to fill and to make ice....nothing .....

all I am Just getting is the flashing when opening the door and nothing happens.....   

How is the optics board suppose to work when the door is closed???

what else could i check for??  optics board ??  I am point to the optics board but just don't want start replacing parts...

Offline channel32a

  • VIP Member
  • Member Since: Apr 2009
  • Posts: 5
Re: kitchenaid (icemaker problem) wiring harden troubleshooting
« Reply #5 on: April 27, 2009, 10:11:31 PM »
How can you test the optics board????