Bosch dishwasher, not completing cycle, E01 error, Customer Service program E32

[gmd357]

Hello, I have a model SHX4AT55UC/14...at first, the DW was stopping just short of the final rinse cycle. Now it only runs about 25 mins. It give me the E01 error. I have replaced the control module but the condition is the same. I have run the customer service program and it throws an E32 error right away. Bosch customer service could not tell me what an E32 error was and its not in the manual.
Other than it not completing the full cycle, everything seems to be working fine. I can hear the water filling the tub, its doing the pre-rinse, its seems to be draining fine. After the half hour or so, once it stops, the water inside is hot. One thing I have noticed is the detergent door is still closed.

Any help would be greatly appreciated.

[Bearcat]

Was the E 32 error in a digital display, or did you have to match flashing lights to determine that code?

E01 is a heating error code.  The heater is in the wash motor on Bosch dishwashers.

Bearcat

[gmd357]

Bearcat, It was in the digital display. Frustrating that the code was not in the manual and/or Bosch customer service didnt know it either. It is working fine now though. I tore the whole machine down and inspected everything. Made sure all was put back together well and it worked. I must have had something loose somewhere. Its been working fine for a couple of months now.