Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Washer Not Getting Water  (Read 354 times)

Offline mstrlucky74

  • VIP Member
  • Member Since: Sep 2022
  • Posts: 1
Washer Not Getting Water
« on: September 05, 2022, 08:59:40 AM »

Attached is my washer manual. The washer is not filling up with water. The water goes through the plumbing up to the washer fine but does not enter. An appliance guy said the main control board needs to be replaced. How can I verify that's the issue. The washer is in my rental house so I need to drive 5 minutes to the house in order to do any diagnostics.

I asked him if any error codes were coming up and he said no because the main board is bad it will not give any codes.

He's charging $600 for the board and to replace it. Thanks.

Thank you very much.

Offline Pnwdad1981

  • Technician
  • Member Since: May 2020
  • Posts: 131
  • Country: us
  • Professional appliance tech for over a decade
    • Buy me a beer through paypal
Re: Washer Not Getting Water
« Reply #1 on: September 15, 2022, 08:56:07 PM »
In 10 years of washer repair Iíve never seen a main be the issue for No fills. Most folks donít no crap about Samsungs so everything must be a board issue. Hard to say without seeing the unit but if itís not turning on then probably the board. Also could be sediment in fill valve screens, bad harness, open solenoids on fill valve assembly, motor issues not completing start program loop. Hope it is the board and you donít get the runaround!
🌲PNW Chris🌲