Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Clothes washer DIY inlet valve  (Read 419 times)

Offline popper

  • VIP Member
  • Member Since: Aug 2022
  • Posts: 1
Clothes washer DIY inlet valve
« on: August 09, 2022, 04:35:18 PM »

Hi  all,
  I'm trying to resolve the water hammer on a Speed Queen clothes
washer. What I plan to do is build a DIY mixing valve using third
party valves. One concern I have is the current draw. Under a no
load measurement it pulls 1.3 amps when energized. I haven't measured
the draw of the OEM valves , but there is a 7W marking on it.

Can installing these new valves damage the circuitry inside the washer
(IE: burn components, melt wiring, etc)?

Thank You for any consideration,

Offline mjappliance

  • VIP Member
  • Member Since: May 2018
  • Posts: 6
  • Country: us
Re: Clothes washer DIY inlet valve
« Reply #1 on: August 09, 2022, 06:05:33 PM »
Sioux Chief 660-H mini rester is what I use and have installed them on many washers