Speed Queen washer model AWN43RSN115TW01 with s/n 1802002646

[Thorning]

This Speed queen washer was  sold to me for scrap price since it apparently has a water leak on the underside of the outer tub. I suspect the outlet tube is rusted out where the hose attaches. So far I have not taken this unit apart to verify the problem. My question to any other techs is this typical of this model  ? The unit is very clean inside and out. Also can this be repaired or is the metal too thin to patch ? A new outer tub is very expensive and I doubt if it is covered under any warranty. Your input is really needed.

[Pnwdad1981]

Tig weld it. But we’ll never know without looking. Maybe mice had a dinner date?

[Dash]

That is not typical for a Speed Queen washer.  What is more common is for the center rotating seal to go bad and leak.  That can be repaired though it isn't easy.

[Thorning]

After the cover was removed it was indeed a leak at the shaft seal as seen under the tub. The leak is not bad but probably leaks about a cup of water during a typical cycle. I may sell it as is with the warning that it must be used on a drain pan or in a basement area with a drain access. If I tear it down myself I need info on a seal and bearing kit  and the repair manual instructions. Can someone assist ?

[Dash]

You'll need 766P3A hub, seal & bearing kit.  Kit comes with instructions.  The diecast aluminum hub is usually difficult to remove.  I start by spraying penetrating oil to the drive shaft and then using a 3-jaw puller on the hub.  Sometimes the puller doesn't work so I end up using a hammer and cold chisel to break off the old hub.  After that the job is straight forward.  Rarely do you need the lower bearing.

[Thorning]

New parts including a tub and internal parts furnished free gratis by Speed Queen factory. These were installed by the local dealer and the unit is now up for sale.

[Pnwdad1981]

How did you swing that without proof of purchase? Or are they really that good old fashioned service?

[Thorning]

I make sure they understand that I am a number 1 fan of their products and promote the products whenever and where ever possible. I have Speed queen products in my home and after working on many different brands  (1300 units) over the last 15 years I see the good, the bad , and the ugly. The Speed Queen products cost more to start with but are worth it.