Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

« previous next »
Pages: [1]   Go Down

Author Topic: Maytag washer model LAT414AAL  (Read 1047 times)

Offline Thorning

  • Technician
  • Member Since: Jun 2013
  • Posts: 1164
Maytag washer model LAT414AAL
« on: August 19, 2021, 01:51:44 PM »

I am in the middle of repairing the above model . It has s/n A0202125K and the agitator p/n22001821  has stripped out the internal splines. It appears that a replacement is available but at quite a high price. A part is listed on E Bay but I am a little reluctant to buy this as I suspect it is also worn in that area. Any suggestions  ?
Logged

Offline Thorning

  • Technician
  • Member Since: Jun 2013
  • Posts: 1164
Re: Maytag washer model LAT414AAL
« Reply #1 on: August 21, 2021, 04:46:17 PM »
 I was able to clean out the damaged splines from the inside of the plastic bore of the agitator  , I then put a longer screw in to hold it in place on the splined shaft. This screw goes in from the side  not the top. It should hold the agitator in place for quite a while.
Logged
Pages: [1]   Go Up
« previous next »