Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Kenmore rinse/drain  (Read 153 times)

Offline Jayber

  • VIP Member
  • Member Since: Oct 2020
  • Posts: 1
Kenmore rinse/drain
« on: October 22, 2020, 03:15:15 PM »

Model : 110.25132411
I've ran diagnostics and get no codes.
I've checked splutch cam.
Replaced shift actuator.

Sometimes drain pump works sometimes hums.  Motor agitator works fine but sometimes motor hums while spin cycle.  Motor windings test good, capacitor tests good, and pump motor ohms out good.  I started the spin cycle and test voltage at capacitor connector and only get 3vac.  Should I assume the control board is bad?

Offline Dash

  • Technician
  • Member Since: Sep 2015
  • Posts: 103
Re: Kenmore rinse/drain
« Reply #1 on: October 26, 2020, 04:34:11 AM »
What is problem with machine?  Does it complete a cycle but make a humming noise?  Have you put machine in manual diagnostic mode and pumped out water?

Offline Blaiser

  • Technician
  • Member Since: Jun 2011
  • Posts: 807
  • Country: us
    • Buy me a beer through paypal
Re: Kenmore rinse/drain
« Reply #2 on: October 29, 2020, 10:14:05 AM »
You probably have a bad capacitor on the board.