This unit skips spin cycles and then will go back to filling. I cannot catch it in the act where it should switch from agitate to drain & spin. I have already replaced the ATC/LS switch to no avail. If I break power to the unit it appears to go back to normal operation for the next step of the cycle. It will pump and spin which would indicate the pairs of 7 and 14 contacts are making but will not engage on their own. Time delay driver issue for timer? Can someone give me some troubleshooting tips on this unit? This looks like one of the last editions of the Whirlpool direct drive designs and they were experimenting with individual microprocessor controls before the went to their vertical modular design. Am I correct? Any help would be greatly appreciated. Thanks in advance and blessings.