Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Maytag MTW6700TQ1 Washer will not fill with water  (Read 299 times)

Offline TroutKiller

  • VIP Member
  • Member Since: Feb 2020
  • Posts: 1
Maytag MTW6700TQ1 Washer will not fill with water
« on: February 10, 2020, 11:29:42 PM »

Washer will start to fill with water, lid locks, water stops, tub starts spinning and goes into wash cycle, but will not continue to fill up with water.  Any advice?  Think it might be the water inlet valve, but not certain.  Thank you!

Offline haroldsappliance

  • Technician
  • Member Since: Nov 2011
  • Posts: 883
  • Country: us
  • No bull no excuses since 1988
    • Appliance Repair
Re: Maytag MTW6700TQ1 Washer will not fill with water
« Reply #1 on: March 09, 2020, 05:35:56 AM »
There is a tech booklet inside on the front cabinet.I would put this thing in diagnostic mode and check for fault codes. Find out what they mean and then remove them. Many times I simply remove faults. Write them down and the remove. Sometimes you may have a fault that says that you have a bad lid lock where in fact the lid lock is not faulty. That is just an example.