Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: GE Profile #WPPRE6150K2WT  (Read 58 times)

Offline Blaiser

  • Technician
  • Member Since: Jun 2011
  • Posts: 710
  • Country: us
    • Buy me a beer through paypal
GE Profile #WPPRE6150K2WT
« on: December 03, 2019, 06:24:10 AM »

GE Profile Washer WPRE6150K2WT when plugged in and start button pushed starts to pump out. Run Diagnostics no errors then overfills with not advancing to agitate cycle. Cleaned bell housing on side of tub that attaches to impulse tube but still over fills with wate. Not too familiar with GE Washers actually dispose them! Any one know what I can diagnosis next ? This has a computer board and the water sensor has been replaced with impulse tube already still overfills ?  Iím thinking board - if I blow into the tube it will advance to agitate??

Offline Blaiser

  • Technician
  • Member Since: Jun 2011
  • Posts: 710
  • Country: us
    • Buy me a beer through paypal
Re: GE Profile #WPPRE6150K2WT
« Reply #1 on: December 03, 2019, 11:24:56 AM »
UPDAtE FIXED!!!

Pin hole in impulse tube was leaking pressure going to water Level switch - wear mark where the tube and shock meet Fron rubbing!  All fixed!