I have a Kenmore Elite Dishwasher, #665.16059402 that has been stopping after the wash cycle. I found a Youtube video that if I pushed the High Temp Button then Energy Saver 5 times alternating between the buttons it might reset it. It seemed to work for a couple of times then it stopped. I wasn't around and my wife then found my note and pushed each button 5 times and it seemed to lock the dishwasher where it wouldn't run at all.
I finally found the Tech Sheet under the washer kickplate and found I should push the Heated Dry, Normal, Heated Dry, Normal in less than 6 seconds. I did that and the washer started through its test cycle and seems ready for another load of dishes. We haven't run another wash load yet but I'm afraid it may stop again. I took the top of the washer door apart and looked at the circuit board but see no obvious burn spots on any of the terminals. What is my next step if (when) the washer stops again. It is a 13 yo washer so I'm questioning how far I should go with it.
Thanks for your ideas!