Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Kitchen Aide Model # KDTE404DSS0  (Read 235 times)

Offline Caddy4343

  • VIP Member
  • Member Since: Oct 2007
  • Posts: 231
Kitchen Aide Model # KDTE404DSS0
« on: June 05, 2019, 01:26:47 PM »

On this unit the "Light" wash cycle light stays faintly lit up all the times.  You can press any cycle button and it will change cycles ok but won't rinse on any cycle.  There is always a little soapy water left in the bottom after it shuts off and the "add dish" and "washing light" flash.  It will rinse and drain just fine if you press "Rinse Only".   All help is greatly appreciated. 

Offline dab147315

  • Technician
  • Member Since: Oct 2010
  • Posts: 5161
  • Country: us
Re: Kitchen Aide Model # KDTE404DSS0
« Reply #1 on: June 05, 2019, 03:38:23 PM »
WPW10469574 vent motor could be loading down the low Voltage side or something else like a corroded optical sensor. Try to disconnect the vent motor harness first and see what happens.Sometimes you can get crazy codes pop up too.Have you ran the diagnostic yet.

Offline Caddy4343

  • VIP Member
  • Member Since: Oct 2007
  • Posts: 231
Re: Kitchen Aide Model # KDTE404DSS0
« Reply #2 on: June 05, 2019, 04:26:42 PM »
Thank you for your help.  I haven't run diagnostics yet.  Thanks again.