You have a gas dryer so disconnect this connector! GAS DRYER: Remove the P14 connector, then measure the resistance between P14-3 (red-white wire) and P14-6 (red-white wire) at the connector. ➔ If the resistance is OK, check P14-3 and P14-6 to machine ground.
➔ If resistance is greater than 0 (zero), replace wiring harness.
The following table gives temperatures and their associated resistance values.
You should have about 11 thousand ohms at 70 degrees. There is also a chart you can follow at different temperatures. So with the connector removed you're measuring the wiring harness to the thermistor for a complete circuit and should read about 11 thousand ohms.