Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Repairing wire harness  (Read 70 times)

Offline Matzie66

  • VIP Member
  • Member Since: Jan 2016
  • Posts: 118
  • Country: ca
Repairing wire harness
« on: May 17, 2019, 09:56:48 PM »

Washer is a frontload Whirlpool model# WFW6620HC0. When replacing control board#W11322905 wire harness connector(green) broke when
trying to remove from board. Is there a temporary fix to connect 2 wires to control board? Would be a delicate process. Wire harness is special
order in Canada.   Thanks   Rene

Offline tcarmen

  • Technician
  • Member Since: Dec 2018
  • Posts: 39
Re: Repairing wire harness
« Reply #1 on: May 18, 2019, 10:33:00 AM »
Can you post a pic of the board where the connector/wire broke off?

Offline Matzie66

  • VIP Member
  • Member Since: Jan 2016
  • Posts: 118
  • Country: ca
Re: Repairing wire harness
« Reply #2 on: May 18, 2019, 11:18:56 AM »
Hi
   No I can,t. I have wire harness on order.I,m thinking the only way to repair with electronics is
replace whole section of wire harness.Not sure why the one connector plug was so hard to remove?
This board was different than one I ,ve ever seen--not even sure if it has locking tabs.Did get in there
with a little flat screwdriver but sure didn,t seem like any locking tabs.

Offline tcarmen

  • Technician
  • Member Since: Dec 2018
  • Posts: 39
Re: Repairing wire harness
« Reply #3 on: May 18, 2019, 12:51:31 PM »
Sorry, no idea without a pic.

I can't find a picture of the board online either.