Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Maytag oven model# AGR5835QDW  (Read 410 times)

Offline Jimstowing

  • VIP Member
  • Member Since: Nov 2014
  • Posts: 4
Maytag oven model# AGR5835QDW
« on: March 11, 2019, 03:26:10 PM »

Oven temperature won’t regulate, digital readout says 100 degrees all the time even though it burns everything.

Offline Bearcat

  • Technician
  • Member Since: Jan 2019
  • Posts: 78
  • Country: us
Re: Maytag oven model# AGR5835QDW
« Reply #1 on: March 12, 2019, 10:35:07 PM »
I took a look at the wiring diagram for this unit.  Check your oven sensor, it should read approximately 1080 ohms at room temperature.  If this is correct, you could try cutting out the connector to the oven sensor and using wire nuts.  If this doesn’t help, you are most likely looking at a control board part number Wp74008640.  The oven sensor is part number 12001655.

Bearcat

Offline Jimstowing

  • VIP Member
  • Member Since: Nov 2014
  • Posts: 4
Re: Maytag oven model# AGR5835QDW
« Reply #2 on: May 21, 2019, 02:08:31 PM »
Replaced sensor, still doesn’t regulate. Next would be the control board, or should we just scrap it and buy a new one?

Offline Jimstowing

  • VIP Member
  • Member Since: Nov 2014
  • Posts: 4
Re: Maytag oven model# AGR5835QDW
« Reply #3 on: May 21, 2019, 02:23:59 PM »
Temp defaults to 100 degrees when it's turned on.. it never moves after it warms up. Oven gets very hot. Do you think a control board will remedy this issue?

Offline johnboy3

  • Technician
  • Member Since: Nov 2012
  • Posts: 334
  • Country: us
Re: Maytag oven model# AGR5835QDW
« Reply #4 on: May 21, 2019, 09:47:10 PM »
Try setting it on the lowest bake temp available, probably about 170 deg.F,  Does it still overheat?  If so, the board likely has a bad relay. To confirm, unplug the oven or turn off the breaker.  Pull wires to bake and broil off the board connectors then check continuity through the relays.  If you have continuity, the board is bad.