So I started the DW cycle and walked away. A few minutes later I noticed the DW had shut off. So I checked the circuit breaker and it was not tripped but the GFI was tripped. When I reset the GFI the DW motor was running and it continued to run even with the door open but it wasn't running in a cycle. So I tapped the side thinking the float was stuck and it finally went off.
I then set the cycle to start the wash and although it ran thru the cycle fine it really seemed to labor. The dishes were clean but I am a little leary.
Anyone else had a similar experience?
Not sure why it tripped the GFI, never done this??
Not sure why it kept running but not running a cycle??