Author Topic: Maytag top load Washer is still full of water at end of cycle (Read 9320 times)

123123123 · « **on:** October 18, 2008, 07:52:58 PM »

Older Maytag top load washer (sometimes) still has full tub of water at very end of cycle. However, the pump works fine cause it pumps the water out the first half of every cycle.

Model LAT9206BAE

Al Capone · « **Reply #1 on:** October 18, 2008, 08:16:11 PM »

Hi,

Whats the model number?

123123123 · « **Reply #2 on:** April 21, 2009, 12:10:17 PM »

LAT9206BAE

JWWebster · « **Reply #3 on:** April 21, 2009, 12:32:01 PM »

When you get to the point the pump and motor quits in the cycle immediately move the timer to the wash pumpout point and see if the water can be pumped out on the wash mode. If it works in wash mode at the spin portion then you have a bad timer. If it does not spin then the motor is getting hot and failing. Feel the motor. If it is hot as hell then it probably has bad bearings. Run the motor with the pump belt off to see if the pump is dragging down the motor. On these here particular pumps you don't have too many failures but they do get stiff over time.

JWWebster · « **Reply #4 on:** April 21, 2009, 12:32:50 PM »

I have one of them pumps left over from stock(new and still in bag) I will cut loose of cheap.

123123123 · « **Reply #5 on:** April 22, 2009, 11:46:27 AM »

Okay, I'll try those things and let you know what the result is.

Thanks!

-Jason

123123123 · « **Reply #6 on:** April 22, 2009, 01:04:38 PM »

JW,

Just to clairify. Do you mean, when the washer gets to the point -at the very end of the wash cycle when the clothes are ready to be removed - the pump and motor quit - then move the dial?

JWWebster · « **Reply #7 on:** April 22, 2009, 01:28:56 PM »

right.

Get Answers to your Appliance Repair Questions

ApplianceJunk.com

Appliance Repair Forum