this model has a 'fuse' that is side mounted on the control module/pc board but it is independently removable/replaceable
the parts diagram i have found doesn't really identify it as located on the board and the parts offerings seem to be for s separate unit with a couple jumper wires.
this might be the aftermarket solution. although the original seems to have been designed for specific replacement, I can probably figure a way to install this and zip tie it to something inside the door panel.
but one distinction i see is that the original has not only a fuseable link but a resistor across the terminals. not really sure what they were trying with that from a theory of ops perspective.
don't know what caused it to blow in the first place. when i jump it out the machine runs fine in all cycles. i didn't test the amperage but certainly has no problems that are pushing the 20 amp circuit it is on. if i can get the amperage rating for the fuse i can test amps under operation just to insure that they are somewhere within spec.
thanks for any experience with this unit you can share.