Hello, and thank you in advance for the help!
I woke up to the dryer not having any power. No lights, nothing. I checked the breaker and it was not popped. I reset the breaker and went back to the dryer and it had power. I run a load and realize that it was not heating up. There were no error codes, breakers were still not popped.
I ran the diagnostics and got a nP error code. This means that the correct power is not getting to the dryer to run the heater element. It tells me to reset the breaker. I do. I come back and the dryer is heating and runs 2 loads. It fails again after this.
The diagnostic says its nP again. So I repeat the same steps, but this time it will not heat. I ran the diagnostics 4 times. It did come back with an error code of HS one time. Which means the humidity sensor might have been bad.
I don't believe it's my house's internal wiring as the breaker is not popping and nothing else is affected. The dryer still gets power to run loads, but will just not heat. Where do you think I should my attention first? Would the humidity sensor cause it not heat? Or would the power run through the circuit board and perhaps something in there is shotty? I opened it up and it doesn't smell or look burnt. What do you guys think?