WHIRLPOOL GAS OVEN BAKE & BROIL WONT LIGHT MODEL WFG510S0AS1

[goldenteeking]

BOTH IGNITORS SPARK AND THE GAS FLOWS FOR 1/4 OF A SEC BUT DOESNT LIGHT. BAKE WENT OUT FIRST THEN THE BROIL A COUPLE WEEKS LATER.

[baldwinappliance]

you may need to replace the harness from the DSI to the bake and broil ignitors. some models the wires were just covered in fiberglass and it is possible for the spark to go through the insulation and ground out on the cabinet so you don't get a spark at the probe.  Take the back panels off and look at the wires.  If they are both not coated in thick black rubber then that MIGHT be your problem.  Here is the part number: WPW10701462.  Also attaching the tech manual. If I come across one with the old wire harness then I replace it as it will be a problem sooner or later.  You have to take a few screws off the left side panel in the back and ease it out a bit to have enough access to remove the old and run the new one.

Hope that helps. 

[goldenteeking]

Thanks very much for your help. I really appreciate the insight.