Evening Gents, and Happy Memorial Day!
A big thank you to those that have put up youtube videos and threads regarding changing out the bearings and shaft of a top loader Cabrio...
that being said, my project is at a halt. I am at the point to reinstall my tub and install my new hub, problem being, the tub seems to sit rather low/or the shaft is still too high. Meaning, when the tub is placed back into the washer and the shaft is protruding through, the hub is then placed but cannot bottom out aginst the wash tub. instead it bottoms out on the shaft lip just below the threads. Leaving about a 1/4-1/2" of gap. As i screwed the screws in place that retained the larger hub, the TUB lifted a bit.
I consider myself to be very mechanically inclined feel that I did not miss any steps. I have all the appropriate tools and parts...and this is just driving me nuts.. ive searched and seems that no one has a video or ran into this particular problem..
Whirlpool Cabrio PN WTW6600SW2