I will try to post this here before starting a new thread, but I am having the same problem with my 70 Ser gas dryer. I have replaced the 2 coils, but still nothing. I was reading about testing the OHMs of the thermal fuse and I am not sure if I am doing it right.
I am kind of new to the fluke meter, but I think i have it on OHMS. When I test the two terminals, the meter makes a noise and will jump around as far as the numbers on it go. I have seen it as high as 50 but it usually settles down to 1, and then to 0, but still beeps....
Am I testing the correct part the correct way?
I get no glow at all from the coils. I replaced them. What is next?