Hello. I have a Frigidaire FWT449GFS2 front load washer. During the wash cycle the machine will fill and drain but it will not spin at all. I have followed these instructions on the included tech sheet:
Remove four pin plug from speed control unit. Measure voltage drop between pins 2 and 4.
Voltage was 122.
Remove the nine pin plug and measure voltage drop between the 6 pin and the 4 pin on the four pin plug.
Voltage was 121.
Measure voltage drop between the 3 pin of the nine pin plug and the 4 pin of the four pin plug.
Meter reads 0.
It states that if this reads 0 to check timer contact 24 to 24B.
This where I am lost. I can see this on the diagram but I have no idea what to test on the timer switch. Can anyone point me in the right direction?