Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Maytag PGR5710BDQ Gas Range, Flashing lock light when bake or broil is pressed  (Read 9569 times)

Offline straycatt

  • VIP Member
  • Member Since: Jun 2008
  • Posts: 3

When Bake or Broil is pressed, a flashing lock light is indicated.  Will not start bake cycle.
No F codes displayed.


If you try the self clean cycle, an F9 code appears after about 30-50secs....

Am I correct in guessing it is the ECR??

-Adam

Model PGR5710BDQ

« Last Edit: June 14, 2008, 11:01:00 AM by straycatt »

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3023
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
More than likely a failure of the door latch assembly. One of the interlock switches is not satisfied, causing the flashing response from the ERC. The F-9 further solidifies the latch as the source of the problem. Frequent self-cleaning is contributed as a cause of this failure.

You're looking for a 12001942 latch assembly...apparently hard to find these days. H-m-m-m
« Last Edit: June 14, 2008, 11:16:06 AM by Repair-man »
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline straycatt

  • VIP Member
  • Member Since: Jun 2008
  • Posts: 3
Is there any easy way to confirm the lock??? Is it adjustable, or will it just need to be replaced??

-Adam

Offline Repair-man

  • Technician
  • Member Since: Feb 2008
  • Posts: 3023
  • Country: us
  • The Virtual Repairman
    • The Virtual Repairmans Appliance Help
Sir, I am confirming it for you, as a former senior field service associate for Maytag Corporation. No, there's no adjustment. 3 screws and you're done.
« Last Edit: June 14, 2008, 11:18:34 AM by Repair-man »
"It's only expensive if someone else fixes it for you" -
The Virtual Repairman   www.repair2000.com

Offline straycatt

  • VIP Member
  • Member Since: Jun 2008
  • Posts: 3
Thank you...  Will order it now.  Already yanked out the old one.

-Adam