Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Issue reassembling a Kenmore 90 Series  (Read 2732 times)

Offline Tim Buchinger

  • VIP Member
  • Member Since: Aug 2013
  • Posts: 3
Issue reassembling a Kenmore 90 Series
« on: August 09, 2013, 02:32:24 PM »

I have a Kenmore 90 series that I had to replace the clutch on. The replacement of the clutch went well however I found this pin lying on the ground under the machine when I went to put everything back together and I cannot for the life of me figure out where it goes! I should have taken a picture with a tape measure beside it to better illustrate the size but its probably about 2-3 inches in length.

Any ideas?

http://s7.postimg.org/h0p8yrm9n/Washer_Pin.jpg

Offline dab147315

  • Technician
  • Member Since: Oct 2010
  • Posts: 5165
  • Country: us
Re: Issue reassembling a Kenmore 90 Series
« Reply #1 on: August 09, 2013, 02:59:11 PM »
Thats a shipping pin.You don,t need it.

Offline Tim Buchinger

  • VIP Member
  • Member Since: Aug 2013
  • Posts: 3
Re: Issue reassembling a Kenmore 90 Series
« Reply #2 on: August 09, 2013, 03:27:55 PM »
Well that makes me feel a lot better, thank you very much for the help.

Offline AppTek

  • Technician
  • Member Since: May 2012
  • Posts: 82
  • Country: ca
Re: Issue reassembling a Kenmore 90 Series
« Reply #3 on: August 09, 2013, 04:35:33 PM »
I know a mechanic that found those pins and welded them in place lol. He didn't know why the washer shook so bad when he was done... :rofl:  :oops: