Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Whirlpool Dryer won't Start  (Read 4857 times)

Offline TechnicianBrian

  • Technician
  • Member Since: Dec 2007
  • Posts: 390
  • Country: us
Whirlpool Dryer won't Start
« on: June 04, 2008, 07:19:16 AM »

Model Number: LER5636EQ3 icon, this dryer stopped in the middle of a drying cycle and would not restart. This dryer uses a thermal fuse mounted to the blower housing to open up the motor circuit in the event of a prolonged overheat condition. The primary cause of this failure is usually a restricted or blocked vent, so anytime you replace this fuse, make sure your vent is clear. After doing a quick voltage check of the fuse and measuring 115vac across the two terminals (measuring 0vac would indicate a good fuse) this fuse needed to be replaced.  Now it starts and runs a full cycle.

« Last Edit: June 04, 2008, 07:20:59 AM by AJ »