whirlpool front load washer sud and f35 error codes

[gregaguilar]

this unit is giving me a sud and f35 error code i checked pump its clean okay i belive this error codes pretain to the pressure switch there is no teck sheet just the wrapper attached to the cabinet any input on this would be appreciated

[gregaguilar]

i forgot to post the model number on this unit at first sorry about that guys

[LowSL2]

Faulty pressure switch. It needs to be replaced. A common problem on these machines with steam.

Sent from my DROID BIONIC using Tapatalk 2

[Patricio]

Faulty pressure switch. It needs to be replaced. A common problem on these machines with steam.

Sent from my DROID BIONIC using Tapatalk 2

I wouldn't be to sure about the pressure switch.  I am doing a steamer that is giving the same code, replaced the pressure switch & it did no good.    I have a control board on back order that after a lot of research points that it may be the culprit.   The expected ship date is July 19.   I've cleaned the pump plugged & unplugged all of the connections (there is a lot & it is time consuming) tried putting it into the two diagnostic modes but they are not working correctly.  It goes into a steamer diagnostic one dance earlier than it is suppose to & it's auto diagnostic bows out after the filling starts.

The manual is located in a pouch under the steamer & CCU boards.   By the way there are 3 main control boards, one a motor control board & a steamer board.   Good luck with yours & update us with what transpires.

[Wedgeman55]

I had an F35 ended up being a faulty control board.   I too replaced the pressure switch,  and it did nothing.   Made sure tube was clear and not blocked.    Everything else looked good.   So that could be your bad boy.

[LowSL2]

I do three or four of these a month. In the last year I would have to say only one was a bad CCU.

Sent from my DROID BIONIC using Tapatalk 2

[JWWebster]

F-35 Repair Video

http://youtu.be/4wjhrB-4f20

[gregaguilar]

i too replaced the pressure switch but to no avail. seems like no one really know what the problem is that gives you a sud and f35 on this unites.

[Patricio]

I wish that information on how to test & diagnose electronic control boards were available.   Not just looking for burnt relays & resistors.   I have repaired quite a few machines by just replacing the parts & not knowing what exactly has gone wrong with the electronics.

[lesguns]

Ive installed 2 in the last 30 days-one today.

[gregaguilar]

well I replaced cc board on this bad boy ran a diagnostic on it now when it gets to the hot water fill section the water never stops coming in to the tub now I get a F32 which pertains to faulty pressure switch well what is F35 analog faulty pressure switch Now do I have a faulty pressure switch or a bad water valve? On another site on this subject it tells you to check volt from cc board to pressure switch and if there is volt then replace cc board I would think you would replace the switch since you are getting juice to it. I checkec continuity on all four blue wires from cc board to switch and they test out okay. I am going back and test the water valve. And remember crue I am not getting the F35 code no more? It is the F32 code now. I am going down to my friend down the street he works for Sears maybe he has come across something like this, but so far nobody has been able to come up with the solution when i get the solution I will definitly post it so we can all learn from this. Thanks guys for all your input anyway