Get Answers to your Appliance Repair Questions

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Maytag Centennial TL won't Fill during Wash/Rinse Cycle (MVWC6ESWW1)  (Read 4785 times)

Offline rockinrobin

  • Technician
  • Member Since: Sep 2011
  • Posts: 460
  • Country: us
    • Buy me a beer through paypal
    • Ransom Mobile Appliance Repair Service

This Washer is 2-3 Years Old and it won't fill with water during Wash/Rinse cycle. Also, the tub spins at the beginning of Rinse. ???
Cleared pressure tube and there's no power going to the Inlet Valve.
Therefore, I need to check VAC on wire harness that connects to the Auto Load Sensing Switch during Fill for Wash/Rinse but don't know which wires to check (maybe Blue & Orange)?
I understand that if I have AC Voltage then Timer is OK and I need to replace Sensing Switch.
Also, do you have a Service Manual for this Washer?
 :popcorn:


Offline rockinrobin

  • Technician
  • Member Since: Sep 2011
  • Posts: 460
  • Country: us
    • Buy me a beer through paypal
    • Ransom Mobile Appliance Repair Service
I replaced the Timer and it's working normal again. However, if it acts up again then I'll replace the Temperature Switch.

Offline AJ

  • Technician
    Administrator
  • Member Since: Jun 2007
  • Posts: 10953
  • Country: us
    • ApplianceJunk.com - Appliance Repair
Re: Maytag Centennial TL won't Fill during Wash/Rinse Cycle (MVWC6ESWW1)
« Reply #2 on: April 25, 2013, 09:06:50 PM »
Thanks for the update,  O0