Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Brand Newish Hydrowave Suspension Mess  (Read 1736 times)

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8827
  • Country: us
  • Caregiver, DIYer
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Brand Newish Hydrowave Suspension Mess
« on: April 24, 2013, 02:06:01 PM »

Spent the majority of the morning messing with a new looking Hydrowave washer. The pulley was rubbing the base. I gotta say that  is the crappiest base. It bends easy. A dolly under it can do more harm than good. I took some fender washers and cut out a slot in them where I could shim the support rods. I got it to where it would not rub any more with a full tub of water in it.
« Last Edit: April 24, 2013, 02:06:36 PM by JWWebster »
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair