Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Frigidaire Range no Bake or Broil  (Read 6349 times)

Offline TechnicianBrian

  • Technician
  • Member Since: Dec 2007
  • Posts: 390
  • Country: us
Frigidaire Range no Bake or Broil
« on: May 13, 2008, 09:48:19 PM »

Model #FED367DSA, the surface units of this range worked well, but the oven would not operate in the bake or broil modes. After removing the control panel and accessing the electrical connections, I found 120vac on both the L1 and L2 input terminals so I knew the source voltage was OK. But when I turned on each element, I was getting 120vac from the L1 outputs, but nothing from the L2 output. Just as a double check, I also did a resistance check to verify both elements were still intact and they checked also checked OK. I decided to open the control board and take a look inside and found a nice burn mark on the back side. I replaced the control board and now the oven heats properly again.

« Last Edit: May 13, 2008, 09:49:36 PM by AJ »