Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Whirpool Calypso GVW9959KQ2  (Read 2626 times)

Offline uffmanj

  • VIP Member
  • Member Since: Dec 2012
  • Posts: 1
Whirpool Calypso GVW9959KQ2
« on: December 29, 2012, 06:11:30 PM »

help.

I need help in trying to determine what the cause is for my CI error message.  originally it had the CA error, i checked and replaced the belt since it was broken.  Now i get the CI error roughly at 69-71 seconds into the diagnostic mode.  I was also able to determine that the motor and pulley assembly can spin freely with out the belt attached.  once the belt is attached i can spin it freely clockwise, but when attempting to go counter clockwise, the belt is very hard to turn.. seems like it's brake is engaged.  any thoughts on what i can check?

thanks
jeremy

Offline JWWebster

  • Technician
  • Member Since: Jan 2008
  • Posts: 8827
  • Country: us
  • Caregiver, DIYer
    • Buy me a beer through paypal
    • JW's Sublime Appliance Advice
Re: Whirpool Calypso GVW9959KQ2
« Reply #1 on: December 30, 2012, 10:02:24 AM »
Motor over-amp condition. Strings in pump OR wrong detergent. If it is wrong detergent it will go to 6 mins left and quit mostly. You ain't gotta take the drum out like I did, the bottom plate is removable and gives access to the pump. Take the pump apart and get the strings out. Clic pic to enlarge.   Service Manual

[attachment auto deleted after 5 years by admin]
May the hinges of our friendship
        never grow rusty.

About the icons: The beer is tip link, if a tech saves ya some money buy em a 6 pack. The small green square=personal message. The green dot is a link to my web page on appliance repair