Get Answers to your Appliance Repair Questions

Disclosure: This website contains affiliate links, Meaning I get a commission if you decide to make a purchase through my links, at no cost to you.

Your Privacy Rights

Washer Parts  ·   Dryer Parts  ·   Refrigerator Parts  ·   Dishwasher Parts  ·   Range/Cooktop/Oven Parts  ·   All Appliance Parts 

Author Topic: Duet wfw8300sw05  (Read 2999 times)

Offline zwingli

  • VIP Member
  • Member Since: Aug 2011
  • Posts: 34
Duet wfw8300sw05
« on: June 19, 2012, 08:27:42 PM »

I replaced the control board (not the MCU) in this machine. The display was flickering and the machine would stop in mid load. It did not set any codes . After replacing the board and powering up it worked for a few loads and then started acting up. The diagnostics do not work and it doesn't set any codes. It starts a load and the minutes on the timer will go back and forth between the time and 8. The display will start flickering and then the machine will shut down. I did all the component checks in the tech sheet and everything checks out. I didn't check the motor though.
Any help would be appreciated.