ApplianceJunk.com

Forum Index => Washer Repair => Topic started by: JPG on April 04, 2011, 04:44:10 PM

Title: dead no lights no beeps
Post by: JPG on April 04, 2011, 04:44:10 PM
HI I have a Whirlpool WFW9600TA01 (http://www.repairclinic.com/Shop-For-Parts?s=t-WFW9600TA01-%3d%3d) front loader with I believe with 5 contol boards and the unit has power but is just dead no fault codes lights or beeps.  Is there a specific control which usually breaks on these???? Which would make it just dead like this?    tks   I must first guess would be the 2 right under the lid?? I do not like these new duets at all !!!!!!!!!!!!!     jpg
Title: Re: dead no lights no beeps
Post by: whirlpooltech on April 04, 2011, 05:24:28 PM
Did you open it up and take a look at it?
Did you trace power to any of the boards?

Title: Re: dead no lights no beeps
Post by: JPG on April 04, 2011, 05:59:55 PM
NO I just made sure all connections were good and made sure there was voltage at the end of the cord. I was hoping someone has seen this b 4 and new which board dies???
Title: Re: dead no lights no beeps
Post by: JPG on April 14, 2011, 05:44:11 PM
well look llike it was the main control board p/n w10157913.   finnaly replaced a board on one of these machines and it worked??????????????    JOG