ApplianceJunk.com

Forum Index => Heating & Air Conditioning Repair (HVAC) => Topic started by: robnofziger on December 16, 2009, 09:12:00 AM

Title: Cambridge Agri heater conversion
Post by: robnofziger on December 16, 2009, 09:12:00 AM
Dear sir.  

I'm attempting to do the same conversion (http://appliancejunk.com/forums/index.php?topic=5364.0) on an old Cambridge Agri heater model A60, 60,000 btu unit.  The tag on the gas valve is very deteriorated. The Unitrol model # is ??00 AE-?20  max 1/2 PSI Regulator 60 hz Vac .034 AMP.  I removed the plate next to the on/off valve and the circular gasket looked the same as what you showed in your kit without a spring or any other hardware.  I've gotten the main and pilot orifices changed and need to reduce pressure.  Would the kit you offered to the other person that inquired work for me and if so, would you have another one?  Thanks for your consideration.

Yours,
Rob
Title: Re: Cambridge Agri heater conversion
Post by: Al Capone on December 16, 2009, 10:30:14 AM
Hi robnofziger,

Please be sure to read, Posting Basics - Starting a New Topic (http://appliancejunk.com/forums/index.php?topic=443.0).

Note were it says towards the bottom.

Quote
Please do not ask your own question in a topic.
In other words, please don't hijack the topic and make it yours.
Start your own topic and reference the other topic related to your issue.

I have made your reply into a new topic and referenced the other topic that was related to your issue.

Thanks for posting your questions.
Title: Re: Cambridge Agri heater conversion
Post by: JWWebster on December 16, 2009, 12:00:14 PM
Rob can you post a picture of the valve? you going from propane to nat or vice versa?