ApplianceJunk.com

Forum Index => Washer Repair => Topic started by: needhelp! on October 22, 2009, 06:30:30 PM

Title: How to get to the pressure switch?
Post by: needhelp! on October 22, 2009, 06:30:30 PM
I need to to check my pressure switch on my washer because it is overfilling. How do I remove the switchboard? :o

Model WCSR2090D5WW
Title: Re: How to get to the pressure switch?
Post by: JWWebster on October 22, 2009, 09:04:00 PM
4 screws at the top of the control panel get removed and it is right there. Toe remove the part simply pry up the locking tab a hair and twist that dude. You may not need to replace the part. just blow out the air line to the tub and retry;


GE WASHER MANUAL (http://appliancejunk.com/ge/washer/31-10008.pdf)
Title: Re: How to get to the pressure switch?
Post by: theoldstoveguy on October 23, 2009, 08:37:34 AM
Check the pressure switch hose at the tub, I have seen a lot of them plug up.(30+) Even in the air dome,remove the hose at the switch and blow it out. If that works try some water in the hose and blow it out again.