ApplianceJunk.com

Forum Index => Dishwasher Repair => Topic started by: tomnewf on January 03, 2008, 05:08:59 PM

Title: Kenmore 665 dishwasher chopper assembly cover
Post by: tomnewf on January 03, 2008, 05:08:59 PM
I can't get the cover off the chopper assembly of my kenmore 665 dishwasher(the middlen and top spray arms are not turning. I unscrewed the only torx screw i could see. Is there something else i'm missing?

Thanks

Model 665.16349301
Title: Re: Kenmore 665 dishwasher chopper assembly cover
Post by: AJ on January 03, 2008, 08:13:43 PM
Hi,

Sometimes they can be hard to pull up even after the screw has been removed.
If you are sure there is not another screw holding it down take a needle noise pliers and take hold of it in the hole that the screw come out of.

Give it a good pull and it should break loose.

If you could post the full model number that is listed on the dishwasher model/serial number tag I could look up a diagram for it to see if it's just one screw that holds yours down.

The full model number should be something like 665.XXXXXX



Title: Re: Kenmore 665 dishwasher chopper assembly cover
Post by: AJ on January 06, 2008, 10:59:43 AM
Take a look at the diagram in the attachment.

Top left side there is two number #7 screws holding down part #8 (chopper cover) and #9.

Make sure both screws are out and part #9 is removed too.
After you have both #7 screws out and part #9 removed there should be nothing else holding #8 (chopper cover) in place.