ApplianceJunk.com

Forum Index => Dishwasher Repair => Topic started by: shillion on November 23, 2020, 10:33:42 AM

Title: Kenmore Dw 665.13183k800 will fill and drain but no splashing
Post by: shillion on November 23, 2020, 10:33:42 AM
It won't splash(won't wash) even with expensive new circulation pump. I tried to use test cord to supply 120 volt to motor terminals, it still did not run. What volt should go to the control terminals? It is a variable speed motor.Even at diagnostic, the wash motor was not going. Please help. I cannot upload the partial diagram. There is no provision for attachments. I will try to upload later.
Title: Re: Kenmore Dw 665.13183k800 will fill and drain but no splashing
Post by: shillion on November 23, 2020, 10:39:43 AM
I forgot to mention, this Dw would fill and drain, but would not wash, that means no splashing, even at diagnostic sequence. Again, there is no attachment allowance, so I cannot upload some diagrams.
Title: Re: Kenmore Dw 665.13183k800 will fill and drain but no splashing
Post by: Dash on November 24, 2020, 05:11:41 PM
You have a Whirlpool built dishwasher.  I sure change lots and lots of computers on dishwashers like yours and in fact, will be changing a computer tomorrow on a KitchenAid that is very similar to your Kenmore.
Title: Re: Kenmore Dw 665.13183k800 will fill and drain but no splashing
Post by: shillion on November 25, 2020, 03:11:25 AM
Thank you Dash, I wasn't sure about replacing the control board. If I cannot get it make the wash motor work, I will try the control. I simply cannot make the wash motor run. I don't know what power supply is needed to go to the DC circuit make it run.