ApplianceJunk.com

Forum Index => Washer Repair => Topic started by: TroutKiller on February 10, 2020, 11:29:42 PM

Title: Maytag MTW6700TQ1 Washer will not fill with water
Post by: TroutKiller on February 10, 2020, 11:29:42 PM
Washer will start to fill with water, lid locks, water stops, tub starts spinning and goes into wash cycle, but will not continue to fill up with water.  Any advice?  Think it might be the water inlet valve, but not certain.  Thank you!

Title: Re: Maytag MTW6700TQ1 Washer will not fill with water
Post by: haroldsappliance on March 09, 2020, 05:35:56 AM
There is a tech booklet inside on the front cabinet.I would put this thing in diagnostic mode and check for fault codes. Find out what they mean and then remove them. Many times I simply remove faults. Write them down and the remove. Sometimes you may have a fault that says that you have a bad lid lock where in fact the lid lock is not faulty. That is just an example.