ApplianceJunk.com

Forum Index => Washer Repair => Topic started by: Blaiser on December 12, 2019, 07:38:06 AM

Title: Maytag Bravos XL Canít get into Service Diagnostic Mode??
Post by: Blaiser on December 12, 2019, 07:38:06 AM
Maytag Bravos XL Glasstop Washer Model # MVWB835dw thatís a digital touch pad sensor display will not allow me to get into the Diagnostic mode. This is a touch sensor keypad membrane unlike the ďspongyl keypad that has no give on membrane when pressed. Diagnostic sheet says make sure washer is plugged in and in standby-mode with no lights.

Within 8 seconds press 1st button - 2nd button - 3rd button in sequence it must be done at least 3 times in sequence. This does not do any thing and can not get into service mode. Anyone have any tricks or tips on how to get into diagnostic mode?

Seems like this is a finger print reader type membrane??
Title: Re: Maytag Bravos XL Canít get into Service Diagnostic Mode??
Post by: donsabol on December 16, 2019, 08:32:13 AM
have to be patient ...question is why are you going into diagnostics
 
Title: Re: Maytag Bravos XL Canít get into Service Diagnostic Mode??
Post by: Blaiser on December 16, 2019, 08:36:15 AM
Customer said error code popped up. Trying to diagnose. It acts like itís dead unless I turn dial and shut off and push power button when I try to put in diagnostics but keypad acting like it doesnít respond.
Title: Re: Maytag Bravos XL Canít get into Service Diagnostic Mode??
Post by: tcarmen on December 16, 2019, 04:59:51 PM
If the magic finger dance isn't working, the tech sheet tells you how to determine if the problem is the user interface or board.

There's nothing special going on. It should work if it's not broken.